EZ DETAIL BRUSH DIRECTIONS
IMPORTANT: Never use your EZ Detail Brush on a hot surface!
IMPORTANT: DO NOT BEND THE SHAFT, AGITATE BY PUSHING AND PULLING
The Full Size E-Z Detail Brush is 18" long by 4.5" wide, uses a sturdy handle with a built in rubber knuckle guard and bonded vinyl tip. If you have spoke wheels or other tight areas the Mini E-Z Detail Brush may work better for you. This brush is approximately 13" long and 2.5" wide and fits perfectly between even the tightest spoke wheels, engine bay compartments, etc.
We recommend dipping the brush in warm water and agitating the wheels with your favorite shampoo, wheel cleaner or degreaser. Poke it through the spoke of the wheels and use it around the face of the wheel for a thorough cleaning. This brush is perfect for cleaning the inner barrels of your wheels that are tough to reach. It's also used to clean the wheel wells on cars that have a very tiny gap between the wheel and wheel well. After just one use you'll be amazed at how much easier it is to clean your wheels and how much time you will save. Save your fingers and back from lots of bending over and scrubbing and start using the E-Z Detail Brush.
Use water to rinse off debris, dust or mud from the surfaces that the brush will come in contact with.
Fill a bucket with warm water and a quality soap that produces a good amount of suds. The warmer the water the softer the bristles become.
Submerge the brush in the bucket of warm, soapy water. Visually inspect the area you want to clean. Pick a straight path through nooks, crannies and crevices then insert the brush keeping your wrist inline with the handle. To prevent the bristles from getting caught, gently twist the brush in one direction while removing it. The brush will slide into most nooks and crannies. If you find one that it won't, do not force it!
Rinse surfaces off with water to remove all the soap. Use an electric blower or a soft, absorbent cloth to dry delicate surfaces.
Clean grease or oil off the brush with warm water and soap or a solvent. The bristles are chemical resistant and will withstand strong solvents. Rinse the brush thoroughly with water to remove all soap or solvent from the bristles. Hang the brush to dry.
If the bristles become matted, rinse them in very warm water and hang the brush to dry or hold the brush in front of warm forced air, such as a heater vent or a blow dryer on low setting. The Nylex bristles unique design give it a memory effect that when presented to heat will straighten back out.
